rockwell rw9122.3 sonicrafter 1-3/8-inch universal end cut blade, 3-piece
Buy Low Price From Here Now
Hardened teeth will cut wood, fiberglass, nails, non-ferrous metals, thin sheet metal and hardened fillers. For plunge cuts up to 1-5/8" deep.
Readmore
Technical Details
- 1-3/8-Inch
See more technical details
2010-01-07
By Big Poppa
Great blades and a lot better value than the original Fein blades. And as with most items purchases on Amazon, you can't beat the service.
2009-11-22
By ironrat
these blades are not cheap at your local do it center,you pay $20-$25 each.you order through this co.and get 3 for around that same price.I don,t believe much in the info on commercials about this type blades ability to cut nails,I totaly ruined my original blade trying to cut one nail in a door jamb.over all this type of blade technology will become very useful for the do it yer selfer in the future.
2009-10-24
By CastAway (NC)
Bought these to replace the blade I destroyed trying to cut a single nail in my deck. They might work fine for non-ferrous metals, but hit a steel nail and the blade is ruined. Please take note this is contrary to Rockwell's description of the uses for the blade; it definitely won't cut ferrous metals.
2009-10-04
By Dean Smith (Cleveland)
The blade does get damaged by cutting nails, however, I am building a deck and here's what I learned. The "worn out" blade still cuts the nails because of moderate hand pressure, heat, and friction. The teeth did not really make the "nail cut" much faster because the teeth were gone almost immediately. I save the worn blades for cutting nails "only" and I use the newer "toothed" blades for everything else. Do not discard the worn blades as I have learned the hard (and expensive) way!Rockwell RW9122 Sonicrafter 1-3/8-Inch Universal End Cut Blade, 1-Piece
2009-10-04
By L. Wilder
I ordered the 3 blade pack when I ordered my Rockwell Sonicrafter after reading reviews about the short cutting life these blades seem to have. I'm still on my original blade after 21 plunge cuts into 1 1/2 x 1 1/2 inch pressure treated pine with concrete behind it (i.e. the blade often contacted the concrete), 3 cuts through 3/4 inch flex copper tubing, and 4 cuts though 5/8 inch PT door frames over concrete. The blade is finally showing signs of laboring through a cut. I probably could have used other tools to make these cuts, but it would have been a hassle, been messier, and taken much more time than with the Sonicrafter. If I don't ever use this machine again, it will have been worth the puchase price!
Images Product
Buy Rockwell RW9122.3 Sonicrafter 1-3/8-Inch Universal End Cut Blade, 3-Piece Now
Seja o primeiro a comentar
Post a Comment